Command Description
SAVe:ASSIgn:TYPe on page 206 Sets or queries the assignment of the data to be
saved.
SAVe:IMAge on page 206 Saves the screen image to a file on the USB
flash drive.
SAVe:IMAge:FILEFormat on page 207 Sets the screen image file format used by the
SAVe:IMAGE command and by the SAVE >
Action > Save Image and SAVE > Action > Save
All front-panel operations.
SAVe:IMAGe:LAYout on page 208 Sets or queries the layout to use for saved
screen images.
SAVe:SETUp on page 209 Saves the current state of the instrument into the
specified nonvolatile memory location, or to a file
on the USB flash drive.
SAVe:WAVEform on page 210 Stores a waveform in one of the nonvolatile
reference memory locations, or to a file on the
USB flash drive.
SAVe:WAVEform:FILEFormat on page 211 Sets or returns the format for saved waveforms.
SETUP<x>:DATE? on page 218 Returns the date when the specified instrument
setup was saved.
SETUP<x>:TIME? (Query Only) on page 218 Returns the time when the specified instrument
setup was saved
Status and Error command group
Status and error commands let you determine the status of the instrument and
control events.
Several commands and queries are common to all devices on the GPIB or USB
bus. These commands and queries are defined by IEEE Std. 488.2-1987 and Tek
Standard Codes and Formats 1989, and begin with an asterisk (*) character.
Table 21: Status and Error commands
Command Description
ALLEv? on page 48 Causes the instrument to return all events and
their messages, and removes the returned
events from the Event Queue.
BUSY? on page 51 Returns the status of the instrument.
*CLS on page 75 Clears the Event Queue, Standard Event Status
Register, and Status Byte Register (except the
MAV bit)..
DESE on page 96 Sets and queries the bits in the Device Event
Status Enable Register (DESER).
*ESE on page 106 Sets and queries the bits in the Event Status
Enable Register (ESER).
Command groups
TBS2000 Series Programmer 25
To Next Page
Need help?
General
