S commands
This section lists commands and queries that begin with the letter S.
*SAV
Saves the state of the instrument into a specified nonvolatile memory location.
You can later use the *RCL command to restore the instrument to this saved
state. This is equivalent to selecting the Save Setup option in the Save/Recall
Setup menu. Command only, no query form.
Group
Save and Recall
Syntax
*SAV <NR1>
Related Commands
FACtory on page 119, *RCL on page 197, RECAll:SETUp on page 198
Arguments
<NR1> is an integer value in the range from 1 to 10 and specifies a memory
location. Any settings that have been stored previously at this location are
overwritten.
Examples
*SAV2 saves the current instrument settings in memory location 2.
TBS2000 Series Programmer 205
To Next Page
Loading...
