Tektronix TBS2000 Series

MEASUrement:MEAS<x>:SOUrce<x>
For SOURce1: Sets or queries the source for all single channel measurements.
For delay or phase measurements, sets or queries the waveform to measure from.
For SOUrce2: Sets or queries the waveform to measure to when taking a delay
measurement or phase measurement (two-source waveforms measurements).
Group
Measurement
Syntax
MEASUrement:MEAS<x>:SOUrce<x> {CH<x>|MATH}
MEASUrement:MEAS<x>:SOUrce<x>
Arguments
CH<x> is an input channel waveform, where x is the channel number.
MATH is the math waveform.
Examples
MEASUrement:MEAS1:SOUrce1 MATH sets source 1 of measurement 1 to
math.
MEASUrement:MEAS1:SOUrce1? might return
MEASUrement:MEAS1:SOUrce1 MATH indicating that source 1 of
measurement 1 is set to math.
MEASUrement:MEAS<x>:STATE
Sets or queries whether the specified measurement slot is computed and
displayed. The measurement slot is specified by <x>, which ranges from
1 through 6. For a measurement to display, you must have selected a source
waveform and defined the measurement you want to take and display. You select
the measurement using the MEASUrement:MEAS<x>:SOURCE[1] command.
You define the measurement type using the MEASUrement:MEAS<x>:TYPe
command.
M commands
TBS2000 Series Programmer 185