CALibrate:RESults?
Returns the status of internal and factory calibrations, without performing any
calibration operations. Query only.
The results returned do not include the calibration status of attached probes. The
CALibrate:RESults? query is intended to support GO/NoGO testing of the
instrument calibration readiness: all returned results should indicate PASS status
if the instrument is fit for duty. It is quite common, however, to use uncalibrated
probes (particularly when the instrument inputs are connected into a test system
with coaxial cables).
Group
Calibration and Diagnostic
Syntax
CALibrate:RESults?
Related commands
*CAL? on page 53
Examples
CALibrate:RESults? might return :CALibrate:RESults INIT indicating the
instrument has not be calibrated.
CALibrate:RESults:FACtory?
Returns the status of internal and factory calibration, without performing any
calibration operations. Query only.
Group
Calibration and Diagnostic
C commands
58 TBS2000 Series Programmer
To Next Page
Loading...
Need help?
General
