MEASUrement:IMMed:DELay?
Returns information about the immediate delay measurement. This command is
equivalent to viewing the delay measurement settings on the measurement
readout. Query only.
Group
Measurement
Syntax
MEASUrement:IMMed:DELay?
Examples
MEASUREMENT:IMMED:DELAY? might
return :MEASUREMENT:IMMED:DELAY:DIRECTION FORWARDS;
EDGE1 RISE; EDGE2 RISE.
MEASUrement:IMMed:DELay:EDGE<x>
Sets or queries the slope of the edge the instrument uses for the delay from or to
waveform when taking an immediate delay measurement.
Group
Measurement
Syntax
MEASUrement:IMMed:DELay:EDGE<x> {FALL|RISe}
MEASUrement:IMMed:DELay:EDGE<x>?
Arguments
<x> specifies which waveform to use, where <x> = 1 is the from waveform, and
<x> = 2 is the to waveform.
FALL specifies the falling edge.
RISe specifies the rising edge.
Examples
MEASUREMENT:IMMED:DELAY:EDGE1 RISE specifies that the from
waveform rising edge be used for the immediate delay measurement.
MEASUREMENT:IMMED:DELAY:EDGE1? returns either RISE or FALL.
M commands
174 TBS2000 Series Programmer
To Next Page
Loading...
Need help?
General
