DATa:STARt
Sets or queries the starting data point for incoming or outgoing waveform
transfer. This command lets you transfer partial waveforms to and from the
instrument.
Group
Waveform
Syntax
DATa:STARt <NR1>
DATa:STARt?
Related Commands
CURVe on page 87, DATa on page 89, DATa:STOP on page 93, WFMInpre:
NR_Pt? on page 251, WFMOutpre:NR_Pt? on page 261
Arguments
<NR1> is the first data point that will be transferred, which ranges from 1 to the
record length. Data will be transferred from <NR1> to DATa:STOP or the record
length, whichever is less. If <NR1> is greater than the record length, the last data
point in the record is transferred. DATa:STARt and DATa:STOP are order
independent. When DATa:STOP is greater than DATa:STARt, the values will be
swapped internally for the CURVE? query.
Examples
DATa:STARt10 specifies that the waveform transfer will begin with data point
10.
DATa:STARt? might return :DATA:START 214 indicating that data point 214 is
the first waveform data point that will be transferred.
D commands
92 TBS2000 Series Programmer
To Next Page
Loading...
Need help?
General
