Tektronix TBS2000 Series User Manual

CURSor:FUNCtion
Sets or queries the instrument cursor type. Cursors are attached to the selected
waveform in Waveform mode and are attached to the display area in Screen
mode..
Group
Cursor
Syntax
CURSor:FUNCtion{OFF|SCREEN|WAVEform|VBArs|HBArs}
CURSor:FUNCtion?
Arguments
OFF removes the cursors from the display but does not change the cursor type.
SCREEN specifies both horizontal and vertical bar cursors, which measure the
selected waveform in horizontal and vertical units. Use these cursors to measure
anywhere in the waveform display area.
WAVEform specifies paired cursors in YT display format for measuring
waveform amplitude and time. In XY and XYZ format, these cursors indicate the
amplitude positions of an XY pair (Ch1 vs Ch2 voltage, where Ch1 is the X axis
and Ch2 is the Y axis) relative to the trigger.
VBArs specifies the vertical bar cursor to measure the selected waveform in
vertical units.
HBArs specifies the horizontal bar cursor to measure the selected waveform in
horizontal units.
Examples
CURSOR:FUNCTION WAVEFORM selects the paired cursors for measuring
waveform amplitude and time.
CURSOR:FUNCTION? might return :CURSor:FUNCtion SCREEN indicating
that the screen cursors are currently selected.
C commands
TBS2000 Series Programmer 77

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English