Tektronix TBS2000 Series User Manual

CH<x>:PRObe:UNIts?
Returns a string describing the units of measure for the probe attached to channel
<x>, where x is the channel number. Query Only.
Group
Vertical
Syntax
CH<x>:PRObe:UNIts?
Examples
CH4:PROBE:UNITS? might return :CH4:PROBE:UNITS "V" indicating that the
units of measure for the probe attached to channel 4 are volts.
CH<x>:SCAle
Sets or queries the vertical scale of the specified instrument channel. The value of
<x> can vary from 1 through 4 depending on the instrument model.
Each waveform has a vertical scale parameter. For a signal with constant
amplitude, increasing the Scale causes the waveform to be displayed smaller.
Decreasing the scale causes the waveform to be displayed larger.
Scale affects all waveforms, but affects channel waveforms differently from other
waveforms:
For channel waveforms, this setting controls the vertical size of the acquisition
window as well as the display scale. The range and resolution of scale values
depends on the probe attached and any other external factors you have specified.
For reference and math waveforms, this setting controls the display only,
graphically scaling these waveforms and having no affect on the acquisition
hardware.
This command is equivalent to adjusting the front-panel VOLTS/DIV knob.
C commands
72 TBS2000 Series Programmer

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English