ETHERnet:DHCPbootp
Sets or queries the network initialization search for a DHCP/BOOTP server.
Group
Ethernet
Syntax
ETHERnet:DHCPbootp{<NR1>|ON|OFF}
ETHERnet:DHCPbootp?
Arguments
ON enables the instrument to search the network for a DHCP or BOOTP server
in order to automatically assign a dynamic IP address to the instrument.
NOTE. Do not use DHCP/BOOTP searching if your instrument has been assigned
a static address on a network. If you set this command to ON, the DHCP/BOOTP
search will delete or change your static IP address information.
OFF disables the instrument to search the network for a DHCP or BOOTP
<NR1> = 0 disables the instrument to search the network for a DHCP or
BOOTP; any other value enables the search.
Examples
ETHERnet:DHCPbootp ON sets the instrument to search for a DHCP or BOOTP
server and assigns a dynamic IP address to the instrument
ETHERnet:DHCPbootp? might return 1 indicating the instrument will search for
a DHCP or BOOTP.
E commands
108 TBS2000 Series Programmer
To Next Page
Loading...
