R commands
This section lists commands and queries that begin with the letter R.
*RCL
Restores the state of the instrument from a copy of its settings stored in memory.
(The settings are stored using the *SAV command.) This command is equivalent
to RECAll:SETUp, and performs the same function as the Recall Saved Setup
item in the front-panel Save/Recall Setup menu. Command only, no query form.
Group
Save and Recall
Syntax
*RCL <NR1>
Related Commands
FACtory on page 119, *LRN? on page 164, RECAll:SETUp on page 198, *RST
on page 204, *SAV on page 205, SAVe:SETUp on page 209
Arguments
<NR1> is an integer value in the range from 1 to 10, and specifies a setup storage
location.
Examples
*RCL3 restores the instrument from a copy of the settings stored in memory
location 3.
TBS2000 Series Programmer 197
To Next Page
Loading...
