Tektronix TBS2000 Series

Arguments
<NR1> is the horizontal position expressed as the percentage of the waveform
displayed left of the center of the graticule.
Examples
HORIZONTAL:DELay:POSITION 50 sets the horizontal position to 50%.
HORIZONTAL:MAIn:DELay:POSITION? might
return :HORIZONTAL:MAIn:DELay:POSITION 100 indicating that the
horizontal position is set to 100%.
HORizontal[:MAIn]:DELay:MODe
Sets or returns the horizontal delay mode.
Group
Horizontal
Syntax
HORizontal:MAIn:DELay:MODe {OFF|ON|<NR1>}
HORizontal:MAIn:DELay:MODe?
HORizontal:DELay:MODe {OFF|ON|<NR1>}
HORizontal:DELay:MODe?
Related Commands
HORizontal[:MAIn][:DELay]:POSition on page 151
Arguments
OFF sets the Horizontal Delay Mode to off. This causes the
HORizontal:POSition command to horizontally position the waveform.
ON sets the Horizontal Delay Mode to on. This causes the
HORizontal:DELay:TIMe command to horizontally position the waveform.
<NR1> = 0 sets the Horizontal Delay Mode to off; any other value sets this mode
to on.
H commands
152 TBS2000 Series Programmer