WFMInpre:BYT_Nr
Sets or queries the data width for the incoming waveform. Changing the value of
WFMInpre:BYT_Nr also changes the value of WFMInpre:BIT_Nr.
Group
Waveform
Syntax
WFMPre:BYT_Nr
WFMPre:BYT_Nr?
Arguments
<NR1> is an integer in the range of 1 to 2 that sets the number of bytes per point.
Examples
WFMINPRE:BYT_NR 1 sets the number of bytes per incoming waveform data
point to 1, which is the default setting.
WFMINPRE:BYT_NR? might return :WFMINPRE:BYT_NR 2 indicating that
there are 2 bytes per incoming waveform data point.
WFMInpre:ENCdg
Sets or queries the type of encoding for waveform data transferred with the
CURVe command.
Group
Waveform
Syntax
WFMInpre:ENCdg {ASCii|BINary}
WFMInpre:ENCdg?
W commands
250 TBS2000 Series Programmer
To Next Page
Loading...
