Tektronix TBS2000 Series User Manual

Arguments
FALL specifies to trigger on the falling or negative edge of a signal.
RISe specifies to trigger on the rising or positive edge of a signal.
Examples
TRIGger:A:EDGE:SLOpeRISE sets the A edge trigger to occur on the rising
edge of the signal.
TRIGGER:A:EDGE:SLOPE? might return :TRIGGER:A:EDGE:SLOPE FALL
indicating that the A edge trigger slope is negative.
TRIGger:A:EDGE:SOUrce
Sets or queries the source for the edge trigger. This is equivalent to setting the
Source option in the Trigger menu.
Group
Trigger
Syntax
TRIGger:A:EDGE:SOUrce {{CH1|CH2|CH3|CH4|LINE}
TRIGger:A:EDGE:SOUrce?
Related commands
TRIGger:A:EDGE:SLOpe on page 225, TRIGger:A:EDGE:COUPling on
page 224
Arguments
CH<x> specifies one of the analog input channels. The value of <x> can vary
from 1 through 4 for 4-channel instruments or 1 through 2 for 2-channel
instruments.
AC LINE specifies the AC line as a trigger source.
Examples
TRIGger:A:EDGE:SOUrceCH1 specifies channel 1 as the A edge trigger source.
TRIGger:A:EDGE:SOUrce? might return :TRIGGER:A:EDGE:SOURCE CH1
indicating that channel 1 is the A edge trigger source.
T commands
226 TBS2000 Series Programmer

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English