Tektronix TBS2000 Series

WFMOutpre:NR_Pt?
Returns the number of points for the DATa:SOUrce waveform that will be
transmitted in response to a CURVe? query. The query command will timeout
and an error will be generated if the waveform specified by DATa:SOUrce is not
turned on. Query only.
Group
Waveform
Syntax
WFMOutpre:NR_Pt?
Related commands
CURVe on page 87, DATa on page 89, DATa:STARt on page 92, DATa:STOP on
page 93, SAVe:WAVEform on page 210, SAVe:WAVEform:FILEFormat on
page 211, WFMInpre:NR_Pt? on page 251
Examples
WFMOUTPRE:NR_PT? might return :WFMOUTPRE:NR_PT 10000 indicating
that there are 10000 data points to be sent.
WFMOutpre:RECOrdlength?
Returns the record length for the source waveform as specified by the
DATa:SOUrce command. Query only.
Group
Waveform
Syntax
WFMOutpre:RECOrdlength?
Examples
WFMOUTPRE:RECORDLENGTH? might
return :WFMOUTPRE:RECORDLENGTH 2000 indicating that 2000 is the
source waveform record length.
W commands
TBS2000 Series Programmer 261