Ethernet command group
These commands provide control of the Ethernet feature.
Table 12: Ethernet commands
Command Description
ETHERnet:DHCPbootp on page 108 IP configuration method selection? DHCP or
static ip?
ETHERnet:DNS:IPADDress on page 109 DNS IP address set or query.
ETHERnet:DOMAINname on page 109 Domain name set or query.
ETHERnet:ENET:ADDress? on page 110 Mac query only.
ETHERnet:GATEWay:IPADDress on page 110 Gateway ip set or query.
ETHERnet:HTTPPort on page 111 Http port set or query.
ETHERnet:IPADDress on page 112 Ip address set or query.
ETHERnet:NAME on page 112 Name set or query.
ETHERnet:PASSWord on page 113 Password set or query.
ETHERnet:PING on page 113 Do ping operation.
ETHERnet:PING:STATUS? on page 114 Return ping status: success, no response and
others.
ETHERnet:SUBNETMask on page 114 Netmask set or query.
FFT command group
These commands provide control over the instrument FFT feature.
Table 13: FFT commands
Command Description
FFT? on page 120 Returns all FFT parameters.
FFT:HORizontal:POSition on page 121 Sets or queries the FFT horizontal display
position.
FFT:HORizontal:SCAle on page 121 Sets or queries the FFT zoom factor.
FFT:SOURce on page 122 Sets or queries the FFT source.
FFT:SRCWFM on page 122 Sets or queries the FFT source waveform
display state.
FFT:VERtical:POSition on page 123 Sets or queries the FFT vertical display position.
FFT:VERtical:SCAle on page 123 Sets or queries the FFT vertical zoom factor.
FFT:VERTical:UNIts on page 124 Sets or returns the FFT vertical measurement
units label.
FFT:VType on page 124 Sets or queries the FFT waveform vertical units.
FFT:WINdow on page 125 Sets or queries the FFT window state.
SELect:FFT on page 214 Sets or queries the FFT display state.
Command groups
TBS2000 Series Programmer 17
To Next Page
Loading...
Need help?
General
