Command Description
*ESR? on page 107 Returns the contents of the Standard Event
Status Register (SESR).
EVENT? on page 115 Returns from the Event Queue an event code
that provides information about the results of the
last *ESR? read.
EVMsg? on page 116 Removes from the Event Queue a single event
code associated with the results of the last
*ESR? read, and returns the event code with an
explanatory message.
EVQty? on page 117 Return number of events in the event queue.
*OPC on page 193 Generates the operation complete message in
the Standard Event Status Register (SESR)
when all pending commands that generate an
OPC message are complete.
*PSC on page 195 Sets and queries the power-on status flag that
controls the automatic power-on handling of the
DESER, SRER, and ESER registers.
*RST on page 204 Resets the instrument to factory default settings.
*SRE on page 219 (Service Request Enable) sets and queries the
bits in the Service Request Enable Register
(SRER).
*STB? on page 220 (Read Status Byte) query returns the contents of
the Status Byte Register (SBR) using the Master
Summary Status (MSS) bit.
*WAI on page 247 Prevents the instrument from executing further
commands or queries until all pending
commands that generate an OPC message are
complete.
Command groups
26 TBS2000 Series Programmer
To Next Page
Loading...
Need help?
General
