Tektronix TBS2000 Series User Manual

Table 18: Measurement commands
Command Description
MEASUrement? on page 171 Returns the current MEASUrement settings.
MEASUrement:CLEARSNapshot on page 172 Clears the existing snapshop results and
removes the snapshot window.
MEASUrement:GATing on page 172 Sets or returns the measurement gating.
MEASUrement:IMMed? on page 173 Returns all immediate measurement setup
parameters.
MEASUrement:IMMed:DELay? on page 174 Returns information about the immediate delay
measurement.
MEASUrement:IMMed:DELay:EDGE<x> on
page 174
Sets or returns the slope of the edge used for
immediate delay from and to waveform
measurements
MEASUrement:IMMed:SOUrce1 on page 175 Sets or queries the source for single-source
immediate measurements.
MEASUrement:IMMed:SOUrce2 on page 176 Sets or queries the secondary source for dual-
source immediate measurements.
MEASUrement:IMMed:TYPe on page 177 Sets or queries the immediate measurement
type.
MEASUrement:IMMed:UNIts? on page 180 Returns the units for the immediate instrument
measurement.
MEASUrement:IMMed:VALue? on page 180 Executes the immediate instrument
measurement specified by the
MEASUrement:IMMed:TYPe command.
MEASUrement:MEAS<x>? on page 181 Returns all measurement parameters for the
displayed instrument periodic measurement
specified by <x>.
MEASUrement:MEAS<x>:DELay? on page 182 Returns the delay measurement parameters for
the specified measurement.
MEASUrement:MEAS<x>:DELay:EDGE<x> on
page 182
Sets or returns the slope of the edge to use for
delay “from” and “to” waveform measurements.
MEASUrement:MEAS<x>:SOUrce1 on
page 183
Sets or queries the source for an automated
measurement.
MEASUrement:MEAS<x>:SOUrce2 on
page 184
Sets or returns the channel to which
measurements are sent.
MEASUrement:MEAS<x>:STATE on page 185 Sets or returns whether the specified
measurement slot is computed and displayed.
MEASUrement:MEAS<x>:TYPe on page 186 Sets or queries the on-screen periodic
instrument measurement type for the
measurement specified by <x>.
MEASUrement:MEAS<x>:UNIts? on page 189 Returns the units for the instrument
measurement specified by
MEASUrement:MEAS<x>:TYPe.
MEASUrement:MEAS<x>:VALue? on page 190 Returns the value that was calculated for the
instrument on-screen periodic measurement
specified by <x>.
Command groups
22 TBS2000 Series Programmer

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English