Related commands
ACQuire:NUMAVg on page 41, CURVe on page 87
Arguments
SAMple specifies that the displayed data point value is the first sampled value
that was taken during the acquisition interval. The waveform data has 8 bits of
precision in all acquisition modes. You can request 16 bit data with a CURVe?
query, but the lower-order 8 bits of data will be zero. SAMple is the default
mode.
PEAKdetect specifies the display of the high-low range of the samples taken
from a single waveform acquisition. The instrument displays the high-low range
as a vertical column that extends from the highest to the lowest value sampled
during the acquisition interval. PEAKdetect mode can reveal the presence of
aliasing or narrow spikes.
AVErage specifies averaging mode, in which the resulting waveform shows an
average of SAMple data points from several separate waveform acquisitions. The
instrument processes the number of waveforms you specify into the acquired
waveform, creating a running exponential average of the input signal. The
number of waveform acquisitions that go into making up the average waveform
is set or queried using the ACQuire:NUMAVg command.
Examples
ACQuire:MODe AVErage sets average acquisition mode so that the resulting
waveform is the average of the specified number of waveform acquisitions.
ACQuire:MODe? might return ACQUIRE:MODE AVERAGE indicating that
the displayed waveform is the average of the specified number of waveform
acquisitions.
A commands
TBS2000 Series Programmer 39
To Next Page
Loading...
Need help?
General
