YASKAWA A1000

450 YASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical Manual
B.1 Understanding the Parameter Table
B.1 Understanding the Parameter Table
 Control Modes, Symbols, and Terms
The table below lists terms and symbols used in this section to indicate which parameters are available in which control
modes.
Note: For detailed instructions on each control mode, Refer to Control Mode Selection on page 30.
Table B.1 Symbols and Icons Used in the Parameter Table
Note: If a parameter is not available in a certain control mode, the symbol for that control mode is grayed out.
Symbol Description
Indicates the parameter is accessible in all control modes.
Parameter is available when operating the drive with V/f Control.
Parameter is available when operating t
he drive with V/f with PG Control.
Parameter is available when operating the drive with Open Loop Vector.
Parameter is available when operating the dri
ve with Closed Loop Vector.
Parameter is available when operating the drive with Open Loop Vector for PM motors.
Parameter is available when operating the drive with Advanced Open Loop Vector for PM motors.
Parameter is available when operating the drive wit
h Closed Loop Vector for PM motors.
Indicates this parameter can be changed during run.
Motor 2 Refers to a second motor when the drive is operating two motors. Switch between these motors using the multi-function input termi
nals.
All Modes
V/f
V/f w/PG
OLV
CLV
OLV/PM
AOLV/PM
CLV/PM