YASKAWA DX100 - Page 122

8 System Setup
DX100 8.6 Interference Area
8-57
2. Move the manipulator at the maximum and minimum value positions of
the cube corner using the axis keys.
3. After entering the lengths of the three faces of the cube (axial length)
using the Numeric keys, move the manipulator to the center point of
the cube using the axis keys.
Minimum
value
X-axis
Y-axis
Z-axis
Maximum
value
Cubic
interference
area axis
Minimum
value
X-axis
Y-axis
Z-axis
Maximum
value
X-axis
Y-axis
Z-axis
Center
point
X
Y
Z
长沙工控帮教育科技有限公司
工控帮助教小舒QQ:2823408167