8 System Setup
DX100 8.7 Shock Detection Function
8-79
to display the input buffer line.
II) Press [ENTER] to change the number in the input buffer line.
• When robot specification is added
I) When robot specification is added, move the cursor to the
instruction in the input buffer line and press [SELECT] to dis-
play the DETAIL window.
II) Move the cursor to "UNUSED" of "ROBOT/STATION", and
press [SELECT].
III) The selection box appears.
IV) Point the cursor to the robot to be added and press [SELECT].
V) When the addition of robot is completed, press [ENTER].
VI) The DETAIL window closes and the JOB CONTENT window
appears.
5. Press [INSERT] then [ENTER].
– The instruction displayed in the input buffer line is registered.
To Next Page
Loading...
