13-4
IM DLM6054-01EN
13.4 Saving Measured Data
CAUTION
Do not remove the storage medium or turn off the power when the file icon ( ) in the bottom
left of the screen is blinking. Doing so may damage the storage medium and corrupt its data.
Procedure
File Waveform (Save) Menu
Press File and then the Waveform(Save) soft key to display the following menu.
Set the save destination.
Set the data format (Binary, ASCII, Float).
Set the waveforms to save (CH1–CH4, M1–M4, LOGIC, ALL).
Set how much history data to save (ONE, ALL).
Set the data compression type (OFF, P-P, Decim) and the save range
(Main, Z1, Z2).*
Set the file name.
Saves measured data
Set the size of the compressed file (when Compression is set to P-P or Decim).
* When Data Type is set to ASCII, set the Compression and Range settings.
Setting the Save Destination (File List)
Press the File List soft key to display the following screen.
Folder to save to
Set the folder to save to.
Move the cursor to a folder by using the jog shuttle or the SET key
(by moving it up, down, left, or right), and press SET.
To move to the folder that contains the current folder, move the cursor to this line and press SET.
Set which files to display in the File
List window (*.wdf, *.*).
Updates the File List with the most
To Next Page
Loading...
