14-12
IM DLM6054-01EN
14.6 Accessing the DL6000/DLM6000 from a PC (File
Server)
Procedure
UTILITY Network Menu
Press UTILITY, the Network soft key, and then the Server Setup soft key to display the following
menu.
Set the file server feature to Microsoft Network, FTP, or Web (see section 14.7).
Turns authentication on and off
Set the user name.
Set the password.
Enables or disables anonymous access (only for FTP)
Applies the settings
Check the shared folder.
Explanation
You can access the DL6000/DLM6000 flash memory from a PC connected over an Ethernet network.
File Server Type (Type)
You can select one of the following options.
• Microsoft Network: Select this option if the PC will use the Microsoft network protocol to access
the DL6000/DLM6000 flash memory.
• FTP: Select this option if you will use an FTP client software application to access
the DL6000/DLM6000 flash memory from a PC.
Turning Authentication On and Off (Mode)
You can select whether or not to perform authentication when a PC connects to the DL6000/DLM6000.
If you select OFF, you can access the DL6000/DLM6000 without entering a user name or password.
User Name (UserName)
Using up to 30 characters, set the user name that will be necessary to access the DL6000/DLM6000
from a PC. You can use any of the ASCII characters on the keyboard to enter the user name.
Password (Password)
Using up to 15 characters, set the password that will be necessary to access the DL6000/DLM6000
from a PC. You can use any of the ASCII characters on the keyboard to enter the password.
To Next Page
Loading...
Need help?
General
