13-11
IM DLM6054-01EN
Saving and Loading Data
13
13.6 Saving Other Types of Data
CAUTION
Do not remove the storage medium or turn off the power when the file icon ( ) in the bottom
left of the screen is blinking. Doing so may damage the storage medium and corrupt its data.
Procedure
File Others (Save) Menu
Press FILE and then the Others(Save) soft key to display the following menu.
Set the save destination. See section 13.4.
Set the data format
(FFT, Harmonics, Wave Parameter, Accum Histogram, Serial Bus, Wave-Zone, Snap).
1, 2
Set the data to save (analysis 1 and 2, zones 1–4).
3
Set the file name. See section 13.4.
Saves the data
1
You can only select Harmonics when the power supply analysis option is installed.
2
You can only select Serial Bus when the serial bus option is installed.
3
When Data Type is set to FFT, Accum Histogram, Harmonics, or Serial Bus, you can select 1 or 2.
When Data Type is set to Wave-Zone, you can select an option from Zone1 to Zone4.
Explanation
You can save the following data to the specified storage medium.
• FFT results
• Automated measurements of waveform parameters (Wave Parameter)
• The frequency distribution of the specified area (Accum Histogram)
• Waveform zones (Wave-Zone)
• Snapshot waveforms (Snap)
• Power supply analysis results (Harmonics; optional)
• Serial bus frame lists (Serial Bus; optional)
To Next Page
Loading...
