YOKOGAWA DL6000 Series

10-38
IM DLM6054-01EN
10.9 Searching Waveforms
You can search the displayed waveforms for locations that match the specified conditions. You can
specify up to two search conditions (Search1 and Search2).
Procedure
SEARCH Menu
Press SEARCH to display the following menu.
Set the search condition number (1, 2).
Configure the search conditions.
Turns the display of detected point markers on and off
Set the skip mode (OFF, Hold Off, Decimation).
Set the search start point (using the jog shuttle).
Specify the detected point that you want to display (using the jog shuttle).
Executes a search
Set the detected point number and the search start point.
Configuring Search Conditions (Setup)
Searching for Edges
Press the Setup soft key, the Type soft key, the Edge/State soft key, and then the Edge soft key to
display the following menu.
Set the search type to Edge.
When the waveform to search is a
channel CH1–CH4, M1–M4.
When the Waveform to Search Is a Logic
Signal
Set the slope ( , ).
► section 6.3
Set the hysteresis.
Set the level.
Set the search type to Edge.
Set the waveform to search (Logic).
Set the waveform to search
(CH1–CH4, M1–M4).
or M1 to M4).
Press to set the source (A0–D7).
This is the same as the setting using
the jog shuttle.
Set the slope ( , ).
► section 6.3
Set the source (A0–D7).