18-14
IM DLM6054-01EN
Screen Capture Data Printing and Saving
Item Specifications
Built-in printer (optional) Prints a monochrome copy of the displayed screen at a resolution of 1024 × 768 (XGA)
High Resolution: The horizontal resolution is doubled (2048 × 768; the print size does not
change).
USB printer Prints screen captures on an external printer via USB. Color can be turned on or off.
Supports Epson inkjet printers and HP inkjet printers.
Network printer Prints screen captures on an external printer via Ethernet.
1
Color can be turned on or off.
Supports Epson inkjet printers, HP inkjet printers, and HP laser printers.
File Saves screen capture data to the specified storage medium using one of the following save
modes. The storage medium can be set to internal memory or USB storage.
Output data format can be set to PNG or JPEG. Available color settings are OFF, ON, ON
(Rev), and ON (Gray).
1 On models with the Ethernet option.
Data Storage
Item Specifications
Waveform data Saves waveform data (including history waveforms) to the specified storage medium.
1
The saved data can be loaded into the DL6000/DLM6000.
Available data formats are binary (.wdf), ASCII (.csv), and float (flt). Only binary (.wdf)
files can be loaded into the DL6000/DLM6000.
Waveform data is saved by specifying the data format, the waveform to save, the
range to save (Main, Zoom1, or Zoom2), and the compression method (OFF, P-P, or
Decimation).
Waveform data is loaded by setting the load destination to ACQ memory, REF1
(MATH1), or REF2 (MATH2).
If waveform data is loaded into the ACQ memory, the data is cleared when you start
waveform acquisition.
Setup data Setup data can be saved to the specified storage medium.1 The saved data can be
loaded into the DL6000/DLM6000.
Other types of data Waveform zones can be saved and loaded. Polygonal zones can be loaded.
Snapshot waveforms can be saved and loaded. Automatically measured waveform
parameters can be saved. Serial bus frame lists can be saved. FFT waveform data
can be saved. Histogram data can be saved and loaded.
1 The storage medium can be set to internal memory or USB storage.
Other Features
Item Specifications
Default setup Resets the DL6000/DLM6000 to its factory default settings.
The following settings are not reset: date and time settings, communication interface settings,
settings stored to the internal memory, and language settings.
The Undo command can be used to revert to the previous settings.
Auto setup Automatically sets the voltage scale, time scale, trigger, and other settings to the most suitable
values for the input signals.
The Undo command can be used to revert to the previous settings.
Serial bus auto setup
1
The DL6000/DLM6000 can automatically set the serial bus type (CAN, LIN, UART, I2C, or SPI)
as well as the trigger source bit rate and source level and trigger based on those settings.
Calibration Auto calibration and manual calibration are available.
Setup data (storage and recall) Up to twelve sets of setup data can be stored and loaded from the internal memory.
Environment settings The date, time, and message language can be specified. The click sound can be turned on and
off.
Probe compensation signal
output
Transmits signals from the front-panel probe compensation signal output terminals
(approx. 1 V
P-P
and approx. 1 kHz rectangular wave).
Overview Allows you to view the DL6000/DLM6000 system status.
Self-tests Memory, accuracy, and printer tests are available.
Menu language setting The menu language can be switched.
Help feature Displays a description of the settings.
1 On models with the serial bus option.
18.5 Features
To Next Page
Loading...
Need help?
General
