2-32
IM DLM6054-01EN
section 10.6 for the procedure
You can display a histogram or trend of the selected waveform parameter. In the histogram display,
you can measure values such as the mean, standard deviation, and peak values of the selected
waveform parameter. In the trend display, you can observe the changes in the waveform parameter
over time and use cursors to measure levels.
Automated measurements of waveform parameters can also be displayed in a list.
section 10.7 for the procedure
You can display a frequency distribution histogram (vertical or horizontal) for the specified region of a
repeatedly captured signal. On the histogram, you can measure values such as the mean, standard
deviation, maximum, minimum, peak, and median values. You can also measure X-axis and time
values with the cursors. You can perform calculations using the above measured values.
This feature is useful for measuring jitter.
section 10.9 for the procedure
You can search through the analog, logic, and serial bus signals that the DL6000/DLM6000 has
acquired. You can zoom in on detected points and select which of the multiple detected points to
display.
2.8 Analysis and Searching
To Next Page
Loading...
Need help?
General
