YOKOGAWA DLM4000 Series User Manual

2-74
IM DLM4038-02EN
When XY1 to XY4 Is the Source Waveform
The measurement item to use in the GO/NO-GO determination is the area of XY1 to XY4. For
information on setting how the XY waveform is displayed and how its area is determined, see
chapter 5 of this manual and appendix 1of the Features Guide, IM DLM4038-01EN.
• Upper limit
Configure the GO/NO-GO determination range.
• Lower limit
Set the reference range type (Parameter).
Set the source waveform (XY1 to XY4).
When FFT1 or FFT2 Is the Source Waveform
You can select the measurement item to use in the GO/NO-GO determination from the cursor
measurement items for FFT. For information on setting the cursor measurement items for FFT, see
section 7.2.
• Upper limit
Set the measurement items to use in
the GO/NO-GO determination.
• Lower limit
The reference range type is fixed to Parameter.
Set the source waveform (FFT1 or FFT2).
Configure the GO/NO-GO
determination range.
Enters the selected measurement items
2.23 Performing GO/NO-GO Determination

YOKOGAWA DLM4000 Series Specifications

General

Brand	YOKOGAWA
Model	DLM4000 Series
Category	Test Equipment
Language	English