2-73
IM DLM4038-02EN
Setting a Reference Range Using Waveform Parameters (Parameter)
Press the Parameter soft key to display one of the menus shown below. The menu that is displayed
varies depending on the specified source waveform.
When CH1 to CH8 or Math1 to Math4 Is the Source Waveform
You can select the measurement items to use in the GO/NO-GO determination from all of the items
used for automated measurement of waveform parameters (excluding measurement of the delay
between waveforms). For information on setting automated measurement of waveform parameters,
see section 9.1.
• Upper limit
Set the measurement items to use in the GO/NO-GO
determination.
Configure the GO/NO-GO
determination range.
• Lower limit
Set the reference range
type (Parameter).
Set the source waveform (CH1 to CH8, Math1 to Math4).
Enters the selected measurement items
When LOGIC(L) or LOGIC(A|B) Is the Source Waveform
You can select the measurement item to use in the GO/NO-GO determination from the items used
for time axis measurement of waveform parameters shown below.
Freq, Period, Avg Freq, Duty, Pulse Count, and Delay
For information on setting automated measurement of waveform parameters, see section 9.1.
• Upper limit
• Lower limit
The reference range type is
fixed to Parameter.
Set the source bit.
Set the source waveform
(LOGIC(L) or LOGIC(A|B)).
*
Set the source bit (L0 to L7, A0 to A7, B0 to B7).
*
Set the measurement items to use in the GO/NO-GO
determination.
* You can select CH8 or LOGIC(L), depending on which channel’s corresponding key (CH8 or L) is illuminated.
LOGIC(A|B), A0 to A7, and B0 to B7 are available on models with the /L16 option.
Configure the GO/NO-GO
determination range.
Enters the selected measurement items
2.23 Performing GO/NO-GO Determination
To Next Page
Loading...
