YOKOGAWA DLM4000 Series User Manual

12-11
IM DLM4038-02EN
Manual Setup
After running auto setup, you can change the following settings and display decoded results.
• Source
• Bit rate
• Data bit rate
• Recessive level
• CAN FD standard
• Sample point
• Level used to detect source states
• Hysteresis
Setting the List Display
Press the List soft key to display the following menu.
Set the analysis
number.
Set the list size and the display position
(Full Screen, Half(Upper), Half(Lower)).
Lists the analysis results
Analysis number
Turns zoom linking on or off
When the CAN FD standard is set to ISO
When the CAN FD standard is set to non-ISO
Data before the trigger position (on the left side of the waveform display) is assigned analysis
numbers in descending order (-1, -2, and so on). Data after the trigger position (on the right side of the
waveform display) is assigned analysis numbers in ascending order (0, 1, 2, and so on).
12.3 Analyzing and Searching CAN FD Bus Signals (Option)

YOKOGAWA DLM4000 Series Specifications

General

Brand	YOKOGAWA
Model	DLM4000 Series
Category	Test Equipment
Language	English