12-58
IM DLM4038-02EN
Setting the Serial Bus (Setup)
Note
Using the CH8 Terminal and LOGIC(L) Port
If you perform an analysis or execute a search when using the LOGIC(L) port for input, you cannot specify
CH8 as the source. Press the CH8 key in advance to enable input from the CH8 terminal.
Press the Setup soft key to display one of the menus shown below. The menu that is displayed varies
depending on whether the clock is on or off.
When the Clock Is Off
Set the bit
rate.
Turn the clock on or off (OFF).
Select from CH1 to CH8.
Set the data source state to
be recognized as 1 (H, L).
Set the decoding
start point.
Set the level used to
detect data source states.
Set the hysteresis.
Set the data source.
When the Clock Is On
Turn the clock on or off (ON).
Set the chip select
source.
Set the latch source.
Set the clock source.
Set the decoding start point.
Select from CH1 to CH8.
Set the data source state to
be recognized as 1 (H, L).
Set the level used to
detect data source states.
Set the hysteresis.
Set the data source.
Press the source soft
key and select one of the
channels from CH1 to
CH8 to set that channel’s
source conditions.
12.11 Analyzing and Searching User-Defined Serial Bus Signals
To Next Page
Loading...
