2-25
IM DLM4038-02EN
Setting the Trigger Source (Source)
Press the Source soft key to display the following menu.
Set the data bit rate.
Set the trigger source (CH1 to CH8).
Set the trigger coupling, HF rejection,
and noise rejection.
► section 2.3
Set the recessive level (H, L).
Set the bit rate.
Setting the Bit Rate (Bit Rate)
Set the sample point.
Set the bit rate (20 kbps to 1 Mbps).
Set the sample point.
When the Bit Rate Is Set to User Define
Set the bit rate (250 kbps, 500 kbps, 1 Mbps, User Define).
Setting the Data Bit Rate (Data BitRate)
Set the sample point.
Set the data bit rate (500 kbps, 1 Mbps, 2 Mbps, 4 Mbps, 5 Mbps, 8 Mbps, User Define).
Set the data bit rate (250 kbps to 10 Mbps).
Set the sample point.
When the Data Bit Rate Is Set to User Define
2.11 Triggering on CAN FD Bus Signals (Option)
To Next Page
Loading...
