2-51
IM DLM4038-02EN
Trigger Type (Mode)
Every Start Mode
Press the Mode soft key and then the Every Start soft key.
The DLM4000 triggers when it detects a start condition.
Adr Data Mode
Press the Mode soft key and then the Adr Data soft key to display the following menu.
Set the trigger conditions.
Select whether to include the R/W bit.
R/W Bit Inclusion (Include R/W)
When setting the address in hexadecimal, specify whether to include the R/W bit (ON) or omit it (OFF)
in the address pattern.
Note
You can set R/W bit inclusion (Include R/W) under the conditions listed below. The setting is universal.
• When the I
2
C bus trigger type is Adr Data.
• When the I
2
C bus trigger type is set to General Call and Second Byte is set to Master Adr.
• When the I
2
C bus signal is being analyzed or searched.
2.16 Triggering on I2C Bus Signals (Option)
To Next Page
Loading...
