2-31
IM DL950-02EN
When Performing Duty Cycle or Pulse Width Measurements
Set the filter (Smoothing).
Select Duty or Pulse Width.
Set the pulse to measure
(Positive, Negative).
Set Time Out.
(For the 720281)
When Performing Power Supply Frequency Measurements
Set the center frequency (50Hz,
60Hz, 400Hz).
Set Function to Power Freq.
Set the filter (Smoothing, PulseAverage).
When Performing Pulse Integration Measurements
Select Pulse Integ.
Set the unit and pulse.
Set the unit.
Set the filter (Smoothing, PulseAverage).
Turns over-limit reset on or off
Executes the manual reset of the
pulse count
2.7 Configuring Frequency, Revolution, Period, Duty Cycle, Power Supply Frequency, Pulse Width, Pulse
Integration, and Velocity Measurements
To Next Page
Loading...
