CELL-DYN
®
3/35 Sample Loader TS Guide 9140234B-June 1997
Search
Book TOC
Go Back
28 Oct
1997 20:44
HAZARDS
vi
3. Attach the other end of the ground clip cable and the connector from the wrist strap to the work
mat. (Exception: Some wrist strap cables provide a clip to connect to the same ground source as
the mat cable.)
4. Attach wrist strap to your wrist, make sure the metallic button on the inside of the wrist strap is in
direct contact with your skin.
5. Place PC Boards, removed from the instrument, on the work mat.
6. Replacement PC Boards should be placed on the work mat before removing from the protective
bag and remain on the mat until installation.
Defective PC Boards should be placed in the static-protective bag before removal from the work mat
area.
END
To Next Page
Loading...
