110
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_getting_started_step4_ac.fm
Step 4: Make a connection
Step 4: Make a connection
Select an example
The mobile station (MS) must be connected with the test set in order to perform measurements. The
origination of this connection can either be the mobile station or the test set. Use one of two sections of code
below to fit your testing need.
Test Set initiated connection
The following code queries the test set for the connection status and then stops the program if a connection is
not established. A hard handoff is also performed.
513 !*****************************************************************
514 ! CONNECT CALL
515 !*****************************************************************
516 !
526 !***Page the mobile station***
527 !
528 DISP “Paging mobile station...”
529 OUTPUT Testset;”CALL:ORIG”
530 OUTPUT Testset;”CALL:CONN:STAT?”
531 ENTER Testset;Call_connected
532 IF NOT Call_connected THEN
540 PRINT “Call attempt failed”
550 STOP
560 ELSE
570 PRINT “Call connected”
571 PRINT
580 END IF
581 Tot_timer=TIMEDATE
Mobile Station initiated connection
In this case, there is no need to use atimeout or arm the state change detector. These two functions occur
automatically when attempting a test set originated call.
1 PRINT “Originate a call on the mobile now.”
10 OUTPUT Testset;”CALL:CONN:ARM” !Arm the Call-State-Change Detector
20 OUTPUT Testset;”CALL:CONN?” !Query state
30 ENTER Testset;Callstate
40 IF NOT Callstae THEN
41 PRINT “Call Attempt Failed”
42 STOP
43 ELSE
44 PRINT “Call Connected”
45 END IF
50 !
To Next Page
Loading...
Need help?
General
