100
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_gen_bse_qpch.fm
Configuring the F-QPCH (Forward Quick Paging Channel)
Operating Considerations
The Walsh code number for the QPCH channel is fixed at code 80 from the Walsh 128 set.
When the QPCH state is on, the test set will send out slotted quick pages (single mode) regardless of the
mobile station’s ability to support quick paging. If the mobile station does not support quick paging, the
presence of quick pages should not affect its ability to respond to normal pages.
The QPCH relative to pilot level is sent to the mobile station in the Extended System Parameters message to
allow mobile stations to adjust their expected receiver power level.
When the state of the QPCH is on (see “CALL:QPCHannel:STATe” ), OCNS (see “Configuring the F-OCNS
(Forward Orthogonal Channel Noise Simulator)” ) is calculated based on the channel power when QPCH is
present in the signal. When the QPCH state is off, the output power is not fully calibrated.
Related Topics
“CALL:QPCHannel”
“How Do I Change Code Channel Levels?”
To Next Page
Loading...
Need help?
General
