Agilent Technologies 8960 Series Reference Guide

706
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_ts_cpower.fm
Channel Power Measurement Troubleshooting
Channel Power Measurement Troubleshooting
Possible Setup Issues
IMPORTANT If the Access Probe Power measurement is currently selected and the Trigger Arm setting is
Continuous, all other measurements are disabled. Use the “SETup:CAPPower:CONTinuous”
command to set the trigger arm state to single and retry this measurement.
During remote operation of this measurement, you should configure the Trigger Arm to Single. See
“SETup:CPOWer” on page 528. If single triggering is used during manual operation, press the START
SINGLE key to trigger each measurement.
Digital average power measurement results are affected by the Amplitude Offset value. Use the
“SYSTem:CORRection:GAIN” command to set offset values.
The test set receiver’s expected signal amplitude and channel number (or frequency) must be set up correctly
for accurate measurements. This is normally done automatically (see “Active Cell Operating Mode” ) but can
also be done manually (see “Receiver Control” on page 194) .
See “Triggering of Measurements” on page 218 for a description of each trigger setting.

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English