304
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_mncode.fm
CALL[:CELL]:MNCode
CALL[:CELL]:MNCode
“Diagram Conventions” on page 248
CALL[:CELL]:MNCode
Function Sets/queries the mobile network code (MNC, also referred to as IMSI_11_12 or cell network code).
This parameter can be set any time and will be sent out in the next overhead message.
When escape mode is on (see the “CALL[:CELL]:ESCape[:MODE]” command description), this
parameter is not used.
Setting Range: 0 to 99
Query Range: 0 to 99
*RST Setting 0
Programming Example
OUTPUT 714;"CALL:CELL:MNCODE 10" !Sets the mobile network code to 10.
:MNCodeCALL
[:CELL]
<sp><num value>
? (returns num value)
To Next Page
Loading...
