76
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_meas_adherence_desc.fm
Test Adherence to Standards
Test Adherence to Standards
Standards Table
This table lists the capabilities of the E1962B Test Application. This test capability is effective with the
release of revision B.02.
Table 8. IS-98-D Standards
TIA/EIA-98-D E1962B
1.3 Fundamental Channel Test Mode 1 (F/R RC1) Yes, supports SO2 and SO55 on the Traffic Channel.
1.3 Fundamental Channel Test Mode 2 (F/R RC2) Yes, supports SO9 and SO55 on the Traffic Channel.
1.3 Fundamental Channel Test Mode 3 (F/R RC3) Yes, supports SO2 and SO55 on the Traffic Channel.
1.3 Supplemental Channel Test Mode 3 (Forward RC3) Yes, supports SO32 (TDSO) on F-SCH.
1.3 Supplemental Channel Test Mode 4 (F-RC4 &
R-RC3)
Yes, supports SO2 and SO55 on F-FCH & R-FCH.
1.3 Supplemental Channel Test Mode 4 (Forward RC4) Yes, supports SO32 (TDSO) on F-SCH.
1.3 Fundamental Channel Test Mode 5 (F-RC5 &
R-RC4)
Yes, supports SO9 and SO55 on F-FCH & R-FCH.
1.3 Supplemental Channel Test Mode 5 (Forward RC5) Yes, supports SO32 (TDSO) on F-SCH.
3.1 Frequency Requirements Supports Band Class 0, 1, 3, 4, 5, 6, & 9
3.2.1.1 Idle Handoff in Non-slotted Mode (Test 1) No, requires two synchronized Base Station Emulators.
3.2.1.1 Idle Handoff in Non-slotted Mode (Test 2) No, requires two synchronized Base Station Emulators.
3.2.1.2 Idle Handoff in Slotted Mode on Paging Channel No, requires two synchronized Base Station Emulators.
3.2.1.3 Idle Handoff in Slotted Mode on Forward
Common Control Channel
No, requires two synchronized Base Station Emulators.
3.2.1.4 Idle Handoff to another frequency No, requires two synchronized Base Station Emulators.
3.2.2.1 Neighbor Set Pilot Detection & Incorrect
Detection in Soft Handoff
No, requires Soft Handoff capability and Pilot
Measurement detection.
3.2.2.2 Candidate Set Pilot Detection & Incorrect
Detection in Soft Handoff
No, requires Soft Handoff capability and Pilot
Measurement detection.
3.2.2.3 Active Set Pilot Loss Detection in Soft Handoff No, requires Soft Handoff capability and Pilot
Measurement detection.
3.2.3.1 Access Probe Handoff No, requires two synchronized Base Station Emulators.
3.2.3.2 Access Handoff No, requires two synchronized Base Station Emulators.