361
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_rconfig.fm
CALL[:CELL]:RCONfig
CALL[:CELL]:RCONfig
“Diagram Conventions” on page 248
CALL[:CELL]:RCONfig
Function Sets/queries the current radio configuration.
The radio configuration specifies the base data rate and service options supported.
Data rates for the F-FCH can be set using the “CALL:TRAFfic” commands. Data rates for the
F-SCH can be set using the “CALL:SCHannel” commands.
Radio configurations are often referred to in a shorthand terms. These terms are:
• RC1 (for F1R1)
• RC2 (for F2R2)
• RC3 (for F3R3)
• RC4 (for F4R3)
• RC5 (for F5R4)
Setting Range: F1R1|F2R2|F3R3|F4R3|F5R4
Query Range: F1R1|F2R2|F3R3|F4R3|F5R4
*RST Setting F3R3
Programming Example
OUTPUT 714;"CALL:CELL:RCONFIG F1R1" !Sets the radio configuration to RC1.
:RCONfigCALL
[:CELL]
<sp>F1R1|F2R2|F3R3|F4R3|F5R4
? (returns F1R1|F2R2|F3R3|F4R3|F5R4)
To Next Page
Loading...
