233
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_sync_callstate.fm
Call Processing State Synchronization
Call Processing State Synchronization
Call Processing State Query
The CALL:STATUS:STATE query returns the current call processing state.
This is a list of all possible values for this test application.
•“IDLE”
Idle is returned when the test set is not on a call.
•“PAG”
Paging is returned when the test set is in the process of paging the MS.
•“CALL”
Call is returned when an alert message is sent to the MS during a call setup due to a page.
•“CONN”
Connected is returned when the test set and the MS are connected on a call.
•“APR”
Access probe is returned when the test set has received an access probe.
•“REL”
Releasing is returned when the test set is in the process of releasing the MS from a call using over the air
signalling as part of a MS or BS originated release procedure.
•“HAND”
Handoff is returned when the test set is in the process of handing off the MS.
•“REG”
Registering is returned when the test set is in the process of performing a registration with the MS.
The following command returns the current state of a call:
OUTPUT 714;”CALL:STATUS:STATE?”
See the “Instrument Status Area” on page 699for call processing state information.
To Next Page
Loading...
