494
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_rfanalyzer_description.fm
RFANalyzer Subsystem
RFANalyzer Subsystem
Description
The RFANalyzer command subsystem performs “lower-level” functions that control the test set's measuring
receiver. The measuring receiver includes three separate signal paths:
• Power detector
• Demodulation
• Measurement
Refer to the “Block Diagram” on page 749 for a description of the signal paths.
The RFANalyzer commands allow manual settings to the tune frequency or expected power level to each of
these paths if it is necessary to override automatic settings.
Syntax Diagrams and Command Descriptions
“RFANalyzer” on page 495
To Next Page
Loading...
