673
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_gen_op_overview_man_measurements.fm
cdma2000 Measurement Procedures
Measuring Waveform Quality
Each waveform quality measurement returns a number of measurements which includes rho.
1. Select the Waveform Quality/Code Domain measurement (see “B. Select measurements.” on page 656). A
typical display is shown below.
2. Set up the measurement parameters as needed for your measurement situation (see “B. Set up the
measurement.” on page 658.
Numeric rho is the screen currently displayed. In addition to rho, it also provides the following measurements,
calculated from the same data:
• Time Error
• Carrier Feedthrough
• Phase Error
• Magnitude Error
• EVM
There are graphical measurement results available as a result of performing this measurement. See
“Measuring Code Domain Power and Code Domain Power + Noise” on page 680.
To Next Page
Loading...
