Agilent Technologies 8960 Series Reference Guide

86
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_gen_bse_active.fm
Active Cell Operating Mode
Active Cell Operating Mode
Active cell mode is used to emulate an IS-2000 cell interacting with the mobile station (MS), and is the default
operating mode.
Active Cell Features
The basic features provided by active cell operating mode are:
• Selection of radio configuration.
• Selection of service options (voice echo or data loopback).
• Call setup and disconnection, both mobile station originated and paging.
• Zone-based and timer-based registration controls.
• Hard handoffs between frequency bands and physical RF channels.
• Service option negotiation during access state or on traffic channels.
• Voice echoing through the mobile’s earpiece.
• Automatic frequency control and power ranging of the test set’s receiver.
• Mobile station reported information, such as mobile station parameters.
• Closed loop power control.
Setting the Test Set’s Operating Mode to Active Cell Mode
The active cell operating mode is set using the following test set command:
OUTPUT 714;”CALL:OPERating:MODE CALL”
Related Topics
“CW Operating Mode” on page 92
“CALL[:CELL]:SYSTem” on page 403
“CALL:STATus:CELL:SYSTem[:TYPE]?” on page 391
“IS-2000 Test Operating Mode” on page 91

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English