672
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_gen_op_overview_man_measurements.fm
cdma2000 Measurement Procedures
cdma2000 Measurement Procedures
The following step-by-step procedures explain how to manually perform specific measurements available on
the cdma2000 Test Application. A detailed description of each measurement is given in the Reference
information on the documentation CD-ROM and at the Agilent 8960 support website
(http://www.agilent.com/find/8960support/).
Setup parameters for each measurement are assumed to be set to their default (full preset) values unless
otherwise stated.
NOTE To obtain measurement results a call must first be connected See “A. Establish a call.” on page
656
The following measurement procedures are provided:
• “Measuring Waveform Quality” on page 673
• “Measuring Handoff Waveform Quality”
• “Measuring Digital Average Power” on page 675
• “Measuring Channel Power” on page 676
• “Measuring Access Probe Power” on page 677
• “Measuring Frame Error Rate (FER)” on page 678
• “Measuring Code Domain Power and Code Domain Power + Noise” on page 680
• “Measuring Code Channel Time/Phase Error” on page 682
• “Measuring Gated Power” on page 683
• “Measuring TX Spurious Emissions” on page 684
To Next Page
Loading...
Need help?
General
