380
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_setup_system.fm
CALL:SETup:SYSTem
CALL:SETup:SYSTem
“Diagram Conventions” on page 248
CALL:SETup:SYSTem[:TYPE]
Function Sets/queries the system type that will the mobile station will be handed off to when the
“CALL:HANDoff” command is used.
If handoff system type is the same as active cell system type (see “CALL[:CELL]:SYSTem” ), the
mobile station will be handed off within the current system. If handoff system type is different
than active cell system type, the call will be handed off to the system indicated by this command.
Setting
Range: AMPS
a
|DIGital2000|DIGital95
a. If the active system type is AMPS ( as set by “CALL[:CELL]:SYSTem” ), handoffs to other system types are
not allowed.
Query Range: AMPS|DIG2000|DIG95
*RST Setting DIG2000
Programming Example
OUTPUT 714;"CALL:SETUP:SYSTEM:TYPE DIG2000" !Selects IS-2000 as the handoff system type.
:SETup
CALL
[:TYPE]
:SYSTem
<sp>AMPS*|DIGital2000|DIGital95
? (returns AMPS|DIG2000|DIG95)
* If the active system type is
AMPS, handoffs to other
system types are not allowed.
To Next Page
Loading...
Need help?
General
