439
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_fetch_dapower.fm
FETCh:DAPower
FETCh:DAPower
“Diagram Conventions” on page 248
FETCh:DAPower[:ALL]?
FETCh:DAPower:ICOunt?
Function Queries a digital average power measurement result.
This query returns an integrity indicator followed by a digital average power measurement
result (if results are available).
If the multi-measurement state is on, the result represents the average of a number of digital
average power measurements. Multi-measurement state, by default, is off. To set up
multi-measurements, see “SETup:DAPower:COUNt[:SNUMber]” .
Query • Range: -100 to 100 dBm, 9.91 E+37
• Resolution: 0.01 dB
Programming Example
OUTPUT 714;"FETCH:DAPOWER:ALL?" !Returns integrity, average transmit power.
Function Queries the intermediate count of measurements completed in a multi-measurement.
The multi-measurement state, by default, is off. To set up multi-measurements, see
“SETup:DAPower:COUNt[:SNUMber]”
Query Range: 0 to 999
Programming Example
OUTPUT 714;"FETCH:DAPOWER:ICOUNT?"
FETCh :DAPower (returns Integrity Indicator, then Digital
Average Power measurement results (or average
of results if multi-measurement state is on)).
[:ALL]
?
:ICOunt?
(returns Intermediate Count)
(returns Integrity)
:INTegrity?
To Next Page
Loading...
