163
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_dap.fm
Programming a Digital Average Power Measurement
850 !***Display measurements if the mobile station did not drop the call***
860 OUTPUT A;"CALL:STATUS?"
870 ENTER A;Call_status$
880 IF Call_status$="CONN" THEN
890 PRINT "Integrity indicator = ";Integrity
900 PRINT "Maximum power = ";Avg_power_dbm;"dBm";", ";Avg_power_dbw;"dBW"
910 ELSE
920 PRINT "Mobile station dropped call, invalid results"
930 END IF
940 !
950 !***Return to default call processing states***
960 OUTPUT A;"CALL:CLPCONTROL:REVERSE:MODE ACTIVE" ! Returns to active power control bits
970 OUTPUT A;"CALL:POW:DIG2000 -50" ! Returns cell power to -50 dBm/1.23 MHz
980 !
990 DISP "Test complete"
1000 OUTPUT A;"CALL:END"
1010 END
1020 Timeout: SUB Timeout
1030 PRINT "Program timed out"
1040 CLEAR 7
1050 CLEAR 714
1060 SUBEND
Returned Values
This program returns an integrity indicator followed by a digital average power measurement result (if results are
available).
Related Topics
“Digital Average Power Measurement Description” on page 51
“Digital Average Power Troubleshooting” on page 708
To Next Page
Loading...
