221
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_trig.fm
Triggering of Measurements
Trigger Delay Description
Trigger delay controls the delay time between the trigger and the start of sampling. Resolution is 1
nanosecond per measurement and the units are in seconds. A negative value indicates the sampling should
occur prior to the trigger. The default is zero seconds which is preferred for most measurements.
Related Topics
“Integrity Indicator”
Manual Full Preset Continuous
*RST (Remote) Full Preset Single
Partial Preset No change
Table 12. Trigger Arm Default Settings
Action Trigger Arm
Default Setting
To Next Page
Loading...
